Cool 2 Lighting Circuits 1 Mcb Ideas
Cool 2 Lighting Circuits 1 Mcb Ideas. 19 january 2011 04:13 pm status: Looking back at you set up you have 18 lamps.
Looking back at you set up you have 18 lamps. Its common to have a lighting circuit and then a e/m light supply out of the same mcb, your only limitation to the no' of cables in one mcb is the ensuring the mcb clamp is tight on all. But not two circuits, one for smokes and one for lighting, (2 cables) lumped together in one ocpd.
I Would Say That This Means That It Is Acceptable To Run Smoke Detectors On The Same Circuit As The Lighting.
So you have 13 lamps on your lighting circuit, worst case is that each lamp is valued at 100w. An abb type b mcb. If you mean, for instance, 2 radial socket circuits on one mcb;
During My Assessment Last November My Niceic Assessor Told Me It Was Perfectly Ok To Put 2 Radials In One Mcb, Yet Other Electricians On Another Forum Say You Should Never Do This.
Test and record for each circuit and label connsumers unit correctly. Studyelectrical.com | online electrical engineering learning site The board is fully populated with breakers.
There Should Also Be A Means Of Isolating The Smokes From The Lighting, Ie A Switch Or Fcu.
Absolutely fine using one mcb for 2 circuits. Looking back at you set up you have 18 lamps. 2 lighting circuits one mcb topic summary:
The Total Load Which I Want To Run Is 360W ( 18 X 20W Lamps) 9 Lamps On Each Cirucut.
An assembly of electrical equipment supplied from the same origin and protected against overcurrent by the same protective device.this means any number of cables connected to a breaker is one circuit. 19 january 2011 04:13 pm status: So worst case is a 10amp breaker.
This One, About Which Type Of Mcb To Use For Lighting Circuits, Is Answered By Abb:
2 lighting circuits one mcb topic summary: And the cable i want to use is 2. Consider a callout to a property with a socket fault.
0 Response to "Cool 2 Lighting Circuits 1 Mcb Ideas"
Post a Comment